- MercuryIntrusion.run(points=25, start=None, stop=None)¶
Runs the percolation algorithm to determine which pores and throats will be invaded at each given pressure point.
points (int or array_like) – An array containing the pressure points to apply. If a scalar is given then an array will be generated with the given number of points spaced between the lowest and highest values of throat entry pressures using logarithmic spacing. To specify low and high pressure points use the
start (int) – The optional starting point to use when generating pressure points. If not given the half the lowest capillary entry pressure in the network is used.
stop (int) – The optional stopping point to use when generating pressure points. If not given, then twice the highest capillary entry pressure in the network is used.
The inlet sites are set to invaded to start the simulation. This means that if ‘internal’ pores are used as inlets the capillary pressure curve will begin at a non-zero invading phase saturation. To avoid this either set the inlet pore volumes to zero or add boundary pores to the inlet face, and set their volumes to zero.